Gateway Extrusions offers the following Open Dies without any upfront Tooling Costs required
- Equal Angles
- Un-Equal Angles
- Square Tubes
- Rectangular Tubes
- Round Tubes
- Flat Bar Stock
- 'I' or 'H' Beams
- Tee Sections
- Zee Sections
- Hat Sections
- These are "OPEN DIES" for production runs only, we do NOT stock finished extrusions (NO SAMPLES AVAILABLE).
- Orders of any size will be accepted, but may be subject to a Press Setup fee if below 1,000 LB.
- 6063 alloy is typically extruded, but 6005A (6061 alternative) can be available upon request.
- Custom lengths, Powder-Coat finishes and Anodizing are also available.
- Standard Aluminum Association tolerances apply.
Typical lead times below:
- Mill Finish: 3-4 weeks or less
- Standard Paint: 4-5 weeks
- Anodize / Custom Paint: 5-6 weeks